Accuracy:
0.1 % of span
Alarm:
Alarm: settings for low alarm point, low alarm point deadband, high alarm point, high alarm point deadband, off delay, and on delay
Calibration Method:
GLI DRY-CAL Method:
enter the sensor’s GLI-certified “calibration constant” and temperature “T” factor
1-POINT SAMPLE Method:
enter one sample value derived by laboratory analysis or comparison reading
ZERO Method:
With the dry sensor in air, press keys to initiate automatic system zeroing
Current Output:
2 x 0/4 to 20 mA each with 0.004 mA (12-bit) resolution and capability to drive up to 600 Ω loads
Display:
2-line by 16 character backlit LCD
Drift:
0.05 % of span per 24 hrs., non-cumulative
Height :
104 mm
Interface:
RS-232
Material:
Brackets: Zinc-plated steel
Max. cable length Sensor-to-Controller:
91 m
Measuring Range Conductivity:
Selectable:
0-2.000
0-20.00
0-200.0
0-2000
(µS/cm or mS/cm)
Measuring Range TDS:
selectable:
0-9999 ppm
0-9999 ppb
Measuring Range Temperature:
-20 - 200 °C
Memory Backup:
All user settings are retained indefinitely in memory (EEPROM) non-volatile
Mounting:
Panel mounting
Number of Channels:
2 sensor A or B’s measured values or temperatures can be separately displayed, or all four measurements can be displayed together on
one screen. Both outputs are displayed together on a screen. Also, a calculated sensor A and B measurement can be displayed
Operating temperature range:
-20 - 60 °C at 0 - 95% RH (non-condensing)
Power Consumption:
10 VA
Power requirements (Hz):
50 - 60 Hz
Power requirements (Voltage):
180 - 260 V AC
Relative Humidity:
0 - 95 % non-condensing
Relay: Operational Mode:
Each relay (A and B) can be assigned to be driven by
sensor A's or sensor's B selected measurement (conductivity, resistivity or TDS) or temperature
Relay Functions:
Control: settings for high/low phasing, setpoint, deadband, overfeed timer, off delay, and on delay
Status: not configurable; relay only activates when a "fail" diagnostic condition exists
Relays:
2 electromechanical relays; SPDT (Form C) contacts; 5A 115/230 V AC, 5A at 30 V DC resistive
Repeatability:
0.1 % of span or better
Special Notes:
Calculated sensor A and B measurement:
0-100% rejection
0-100% passage
ratio A/B or B/A
difference A-B or B-A
Special notes:
Relay A and B LEDs indicate respective relay status
Storage conditions:
-30 °C to 70 °C
Temperature Compensation:
-20 - 200 °C automatic or manual with selection for temperature compensator (Pt1000 RTD or Pt100 RTD); Linear % per °C slope, built-in ammonia temperature properties table, built-in natural water temperature properties table, or no compensation
to automatic or manual with selection for temperature compensator (Pt1000 RTD or Pt100 RTD); Linear % per °C slope, built-in ammonia temperature properties table, built-in natural water temperature properties table, or no compensation
Temperature Drift:
< 0.03 % of span per °C (zero and span)
Warranty:
12 months
Weight:
0.8 kg
What's included?:
Controller, User Manual